LessStress - Perfektion für Bohrbrillen
LessStress Premium

Introduction

Description
Drill features (front view)
Drill features (rear view)
Accessories
Basic equipment (European)

Working with LessStress
General hints
Measuring the demo lens:
   Step 1
   Step 2
   Step 3
Change to prescription lenses
Drilling

Other features
Notching and slotting
Changes in shape and size
Changing the pantoscopic tilt
Prescription lenses with different thicknesses
Various speeds
Working with blocked lenses

zurückvor

LessStress Premium

General hints

Every drilled job with LessStress follows the same protocol: the two coordinates of a hole refer to a reference point of the Y-axis at 0.00 and the edge of the lens. You will measure holes and notches starting from this point.

You can find a detailed manual with further instructions at Downloads.

Maße

The angle in which the lenses should be drilled are determined by the frame chassis/mounting. If you drill plus or minus lenses - the adjustment of the mounting will be a lot easier if you do not drill vertically but use the angles given by the frame chassis/mounting. If you are not sure about the angle, using an angle of 8° will be close to the optimal angle (drawing 1 and 2).

Bohren konkav

Drill konkav

Bohren konvex

drill konvex


Seite: 0  1  2  3  4  5 6  7  8  9  10  11  12  13  14  15  16  

Design by INCH3 (c) 2005 Interspeed GmbH ::: info@lessstress.de ::: 05204-920667